Juniper Networks EX4200 - Manual (Page 187)

Chapter 12
Performing Initial Configuration
■ Connecting and Configuring an EX Series Switch (CLI Procedure) on page 161
■ Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 163
■ Configuring the LCD Panel Display on EX Series Switches (CLI
Procedure) on page 166
■ Setting the Mode on an SFP+ Uplink Module (CLI Procedure) on page 168
Connecting and Configuring an EX Series Switch (CLI Procedure)
There are two ways to connect and configure an EX Series switch: one method is
through the console using the CLI and the other is using the J-Web interface. This
topic describes the CLI procedure.
Before you begin connecting and configuring an EX Series switch through the console
using the CLI:
■ Set the following parameter values in the console server or PC:
■ Baud Rate—9600
■ Flow Control—None
■ Data—8
■ Parity—None
■ Stop Bits—1
■ DCD State—Disregard
■ To run the ezsetup script, the switch must have the factory default configuration.
If you have configured anything on the switch and want to run ezsetup , revert
to the factory default configuration. See Reverting to the Default Factory
Configuration for the EX Series Switch.
Connecting and Configuring an EX Series Switch (CLI Procedure) ■ 161