Juniper Networks EX4200 - Manual (Page 68)

■ See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch for
port location.
■ See Routing Engine (RE) Module in an EX8216 Switch for port location.
■ Connecting an EX Series Switch to a Management Console on page 153
Management Port Connector Pinout Information for an EX3200 or EX4200 Switch
The management port on an EX3200 or EX4200 switch uses an RJ-45 connector to
connect to a management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T
connection. Two LEDs on the port indicate link/activity on the port and the
administrative status of the port. See “Management Port LEDs in EX3200 and EX4200
Switches” on page 24.
Table 17 on page 42 provides the pinout information of the RJ-45 connector. An
RJ-45 cable, with a connector attached, is supplied with the switch.
Table 17: Management Port Connector Pinout Information for an EX3200 or EX4200 Switch
Description Signal Pin
Transmit/receive data pair 1 TRP1+ 1
Transmit/receive data pair 1 TRP1- 2
Transmit/receive data pair 2 TRP2+ 3
Transmit/receive data pair 3 TRP3+ 4
Transmit/receive data pair 3 TRP3- 5
Transmit/receive data pair 2 TRP2- 6
Transmit/receive data pair 4 TRP4+ 7
Transmit/receive data pair 4 TRP4- 8
Related Topics See Rear Panel of an EX3200 Switch on page 9 for port location. ■
■ See Rear Panel of an EX4200 Switch on page 11 for port location.
■ Connecting an EX Series Switch to a Network for Out-of-Band Management on
page 152
42 ■ Management Port Connector Pinout Information for an EX3200 or EX4200 Switch
Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches