Juniper Networks EX4200 - Manual (Page 190)

Figure 66: LCD Panel in an EX3200, EX4200, or EX8200 Switch
1. Press the Menu button until you see MAINTENANCE MENU . Then press
the Enter button.
2. Press Menu until you see ENTER EZSetup . Then press Enter .
3. Press Enter to confirm setup and continue with EZSetup.
If you have configured a static IP address on your PC, you will not be able to
connect to the switch. To obtain an IP address dynamically, you must enable a
DHCP client on the management PC you connect to the switch.
NOTE: You must complete the initial configuration using the J-Web interface within
10 minutes. The switch exits the EZSetup mode after 10 minutes and reverts to the
default factory configuration, and the PC loses connectivity to the switch.
■ EX2200 switch—The LEDs on the network ports on the front panel blink when
the switch is in the EZSetup mode.
■ EX3200, EX4200, or EX8200 switch—The LCD displays a count-down timer
once you connect the switch to the management PC.
3. From the PC, open a Web browser, type http://192.168.1.1 in the address field,
and press Enter.
4. On the J-Web login page, type root as the username, leave the password field
blank, and click Login.
5. On the Introduction page, click Next.
6. On the Basic Settings page, modify the hostname, the root password, and date
and time settings:
■ Enter the hostname. This is optional.
■ Enter a password and reenter the password.
■ Specify the time zone.
■ Synchronize the date and time settings of the switch with the management
PC or set them manually by selecting the appropriate option button. This is
optional.
Click Next.
7. Use the Management Options page to select the management scenario:
164 ■ Connecting and Configuring an EX Series Switch (J-Web Procedure)
Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches