Juniper Networks EX4200 - Manual (Page 191)

NOTE: On EX8200 switches, only the out-of-band management option is available.
■ In-band Management—Use VLAN 'default' for management.
Select this option to configure all data interfaces as members of the default
VLAN. Click Next. Specify the management IP address and the default
gateway for the default VLAN.
■ In-band Management—Create new VLAN for management.
Select this option to create a management VLAN. Click Next. Specify the
VLAN name, VLAN ID, member interfaces, management IP address, and
default gateway for the new VLAN.
■ Out-of-band Management—Configure management port.
Select this option to configure only the management interface. Click Next.
Specify the IP address and default gateway for the management interface.
8. Click Next.
9. On the Manage Access page, you may select options to enable Telnet, SSH, and
SNMP services. For SNMP, you can configure the read community, location, and
contact.
10. Click Next. The Summary screen displays the configured settings.
11. Click Finish.
The configuration is committed as the active switch configuration. You can now log
in with the CLI or the J-Web interface to continue configuring the switch.
If you use the J-Web interface to continue configuring the switch, the Web session
is redirected to the new management IP address. If the connection cannot be made,
the J-Web interface displays instructions for starting a J-Web session.
NOTE: After the configuration takes effect, you might lose connectivity between the
PC and the switch. To renew the connection, release and renew the IP address by
executing the appropriate commands on the management PC or by removing and
reinserting the Ethernet cable.
Related Topics ■ Connecting and Configuring an EX Series Switch (CLI Procedure) on page 161
■ Installing and Connecting an EX2200 Switch
■ Installing and Connecting an EX3200 or EX4200 Switch on page 113
■ Installing and Connecting an EX8208 Switch
■ Installing and Connecting an EX8216 Switch
Connecting and Configuring an EX Series Switch (J-Web Procedure) ■ 165
Chapter 12: Performing Initial Configuration