John Deere 5310 S - Manual (Page 70)

Drawbar and PTO
PY80265,05I0162 –19–20FEB06–1/1
Adjusting PTO Clutch Operating Rod
PY4487
–UN–17FEB06
PY5016
–UN–21MAY05
PY5019
–UN–21MAY05
PTO Clutch Rod (In Fully Engaged Position)
A—PTO Clutch Lever
B—Clip Pin
C—Jam Nut
D—Arm
E—Clevis
F—Jam Nut
G—Clevis
H—Clip Pin
1. Move PTO lever (A) to rearward (disengaged) position.
2. Remove clip pin (B) from rear end of clevis (E).
3. Remove clip pin (H) from forward end of clevis (G).
4. Check for equal thread engagement at clevis (G).
Loosen jam nuts (F) and (C). Turn rod (D) until threads
on each side of clevis are equal. Tighten jam nut (F).
5. Loosen jam nut (C) from rear of front clevis (E).
6. Adjust length of arm (D) so the clip pin (B) can be
inserted with the rod pulled forward and the arm pulled
rearward to eliminate free play. Lengthen rod by turn of
the clevis to provide PTO clutch lever free play and
PTO clutch rod travel in fully engaged position to
specification.
Specification
PTO Clutch Lever—Free Play 15 mm ........................................................
PTO Clutch Rod (In Fully
Engaged Position)—Travel
14 mm -16 mm ................................................
NOTE: Adjust clevis (G) if you cannot make proper
adjustment with clevis (E).
7. Reinstall clip pin (B & H) in clevis (E & G) respectively
and arm (D).
8. Tighten jam nut (C) at clevis.
65-5
082206
PN=68