Jameco Electronics Rabbit 3000 - Manual (Page 233)

224 Rabbit 3000 Microprocessor
The following I/O read time delays were measured.
The measurements were taken at the 50% points under the following conditions.
• T = -40°C to 85°C, V = 3.3 V
• Internal clock to nonloaded CLK pin delay
≤ 1 ns @ 85°C/3.0 V
The following I/O write time delays were measured.
The measurements were taken at the 50% points under the same conditions that the I/O
read delays were measured.
I/O bus cycles have an automatic wait state and thus require 3 clocks plus any extra wait
states specified.
See Table 16-2 for delays at other voltages.
Table 16-5. I/O Read Time Delays
Time Delay
Output Capacitance
30 pF 60 pF 90 pF
Max. clock to address delay (T
adr
) 6 ns 8 ns 11 ns
Max. clock to memory chip select delay (T
CSx
) 6 ns 8 ns 11 ns
Max. clock to I/O chip select delay (T
IOCSx
) 6 ns 8 ns 11 ns
Max. clock to I/O read strobe delay (T
IORD
) 6 ns 8 ns 11 ns
Max. clock to I/O buffer enable delay (T
BUFEN
) 6 ns 8 ns 11 ns
Min. data setup time (T
setup
) 1 ns
Min. data hold time (T
hold
) 0 ns
Table 16-6. I/O Write Time Delays
Time Delay
Output Capacitance
30 pF 60 pF 90 pF
Max. clock to address delay (T
adr
) 6 ns 8 ns 11 ns
Max. clock to memory chip select delay (T
CSx
) 6 ns 8 ns 11 ns
Max. clock to I/O chip select delay (T
IOCSx
) 6 ns 8 ns 11 ns
Max. clock to I/O write strobe delay (T
IOWR
) 6 ns 8 ns 11 ns
Max. clock to I/O buffer enable delay (T
BUFEN
) 6 ns 8 ns 11 ns
Max. high Z to data valid rel. to clock (T
DHZV
) 10 ns 12 ns 15 ns
Max. data valid to high Z rel. to clock (T
DVHZ
) 10 ns 12 ns 15 ns