Sony Ericsson TT4031 (SE-GM29) - Manual (Page 74)

Owner’s Manual Rev 1.0 Page 74 of 74
This S-parameter represents the decimal IA5 value of the character
generated by the DCE as part of the header, trailer, and terminator for result
codes and information text, along with the S3 parameter (see the description
of the V parameter for usage).
If the value of S4 is changed in a command line, the result code issued in
response to that command line will use the new value of S4.
<value> Description
10 Formatting character. Default value
Note: ASCII character 10 is equivalent to <LF>
0 to 127 Formatting character
3.6 ATS5 Command Line Editing Character (BACKSPACE)
Description Command Possible Responses
Request Command Line
Editing Character
ATS5=<value> •_ OK
•_ ERROR
Shows the current
setting
ATS5? <value>
Show if the command is
supported
ATS5=? S5: (list of supported
<value>s)
This S-parameter represents the decimal IA5 value of the character
recognised by the DCE as a request to delete from the command line the
immediately preceding character.
<value> Description
8 Line editing character. Default value
0 to 127 Line editing character
3.7 ATS6 Blind Dial Delay Control
Description Command Possible Responses