Solid State Logic Soundscape Mixer - Manual (Page 24)

Soundscape Mixpander
Page 24 of 109
Fixed inputs and outputs always connect to an output or input with a matching number. For
instance, an element with a single mono output, (output 1), will always connect to the left side
input, (input 1), of a stereo element, as shown below. This type of configuration should be avoided,
because the presence of an unconnected input can create problems:
...instead, a mixer element with a single output should be connected to a mixer element with a
single input:
1 2
1 2
1
1 Incorrect configuration:
A mono mixer element (Drawmer SDX100
compressor/expander, is connected to a
stereo mixer element (Wave Mechanics
Reverb). Input 2 of the stereo reverb is
unconnected. This could create audible
problems.
1
1
1 2
1
Correct configuration:
A mono mixer element (Drawmer SDX100
compressor/expander) is connected to a
mono to stereo mixer element (Wave
Mechanics Reverb).