Sony IPELA SNC-RZ25P - Manual (Page 33)

A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the System — System setting menu
33
Initialize Tab
Reboot
Reboots the camera.
Click Reboot, and the message “The SNC-RZ25N/
RZ25P will be rebooted. Are you sure?” appears. Click
OK to reboot the camera. It takes about two minutes to
start again.
Factory default
Resets the camera to the factory settings.
Click Factory default, and the message “Set up data
will be initialized. Are you sure?” appears. When you
click OK, the network indicator on the camera starts to
blink. After adjustments of the default settings have
finished, the camera reboots automatically. Do not turn
off the camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning the power on of this unit while pressing the reset
switch on the camera. For details, see the supplied
Installation Manual.
Backup setting data
Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the browser to
specify the folder and save the setting data of the
camera. The file name preset at the factory is “snc-
rz25.cfg.”
Restore setting
Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Then, click OK, and the camera is adjusted
according to the loaded data and restarted.
Note
With Restore setting, some items in the Network setting
menu (page 40) cannot be restored.
Delete user setting URL
By pressing Delete, you can delete the home page
recorded on the flash memory of the camera with
Custom Homepage Installer (page 73).
Delete panorama image
By pressing Delete, you can delete the panorama image
recorded on the camera with SNC panorama creator
(page 71).
Firmware upgrade
Use this when upgrading the camera software. Click
Browse and specify the file for upgrading, then click
OK. The message “Upgrade firmware? Are you sure?”
is displayed. Click OK and upgrading starts. After
completion, the camera starts again.
Notes
• Use only the upgrade file special to this camera. If
not, a problem may occur.
• Do not turn off the camera until the upgrading is
completed.
System log Tab
System log
The data of the software activity of the camera are
recorded in this log. It includes data that are useful when
a problem occurs.
Click Reload to reload the latest data.