Sony IPELA SNC-RZ25P - Manual (Page 43)

A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the Network — Network setting Menu
43
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server.
OK/Cancel
See “Buttons common to every setting menu” on page
29.
Dynamic IP address notification
Tab — Notifying the IP Address
When the DHCP setting is set to On or PPPoE setting is
set to On on the Network tab, you can send notification
of the completion of the network settings using the
SMTP or HTTP protocol.
e-Mail (SMTP) notification
Select On to send an e-Mail when the DHCP setting is
completed.
SMTP server name
Type the name or IP address of the SMTP server to use
for sending an e-Mail, up to 64 characters.
Authentication
Select the authentication required when you send an e-
Mail.
Off: Select if no authentication is required when an e-
Mail is sent.
On: When authentication is required an e-Mail is sent,
select one of the authentication methods from the
followings.
SMTP: Select if authentication is required when an
e-Mail is sent.
POP before SMTP: Select when POP before
SMTP is required when an e-Mail is sent.
Note
When you set to On, make sure to select either or both
SMTP or/and POP before SMTP.
POP server name
It is necessary when the POP before SMTP is selected
in Authentication.
Type the POP (receiving mail) server name up to 64
characters. Or type the IP address of the POP server.
This setting is necessary when the SMTP server which
sends e-Mails performs authentication using the POP
user account.
User name, Password
Type the user name and Password of the user who has
the mail account. This setting is necessary when the
SMTP server which sends e-Mails performs
authentication.
Recipient e-mail address
Type the recipient e-Mail address up to 64 characters.
You can specify only one recipient e-Mail address.
Administrator e-mail address
Type the e-Mail address of the camera administrator, up
to 64 characters. This is used as the reply address or the
address for a system mail from the mail server.
Subject
Type the subject/title of the e-Mail up to 64 characters.
Message
Type the text of the e-Mail up to 384 characters. (A line
break is equivalent to 2 characters.) You can describe
the information of the acquired IP address, etc. using the
special tags mentioned below.
HTTP notification
Select On to output a command to the HTTP server
when the DHCP setting is completed. Using this
function, you can configure a useful system, for
example, to view the access log stored in the HTTP
server or start an external CGI program.
URL
Specify the URL to send HTTP commands, up to 256
characters. The URL is normally composed as follows:
http://ip_address[:port]/path?parameter
ip_address: Type the IP address or host name of the host
to which you want to connect.