Sony IPELA SNC-RZ25P - Manual (Page 41)

A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the Network — Network setting Menu
41
Wireless Tab — Setting of Wireless
Connection
Insert the specified wireless LAN card into the CF card
slot of the camera, and set the matters to connect to the
wireless network.
Use the optional wirless LAN card SNCA-CFW1 for the
wireless connection.
MAC address
Displays MAC address of the wireless LAN card
inserted to the CF card slot.
If any wireless LAN card is not inserted,
“00:00:00:00:00:00” is displayed.
Obtain an IP address automatically
(DHCP)
DHCP server is installed on the network. Select it when
the IP address is assigned by DHCP server. IP address is
assigned automatically.
Note
When you set Obtain an IP address automatically
(DHCP), make sure that DHCP server is working on the
internet.
Use the following IP address
Select this when a fixed IP address is set.
IP address
Type the IP address of the camera.
Subnet mask
Type the subnet mask.
Default gateway
Type the default gateway.
Obtain DNS server address automatically
Select this to obtain the address of DNS server
automatically. It can be set only when Obtain an IP
address automatically (DHCP) is selected.
Note
When you select “Obtain DNS server address
automatically”, make sure that DHCP server is active on
the network.
Use the following DNS server address
Select this when you set the fixed address as the IP
address of DNS server.
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server.
Type
Select the network connection type Ad hoc mode or
Infrastructure mode. Select Ad hoc mode when
connecting to the computer directly, or select
Infrastructure mode when connecting to the computer
via an access point or a radio router. When you select Ad
hoc mode, specify the wireless channel.
Note
The setting of the HTTP port number is common to the
setting of the network cable.
Antenna
When you use dedicated wireless card SNCA-CFW1,
you can select one of the following antenna settings.
Internal: Suitable for short-range sending and
receiving because it is non-directional. Select it when
you use the camera inside.
External: Attaching an external antenna to SNCA-
CFW1 will enable long-range sending and receiving.
Select it when you need long-range sending and
receiving with attached external antenna.
Diversity: Uses either the inside or external antenna
which has higher sensitivity. In this case, the
sensitivity is slightly lower than the settings Internal
and External.