2 technical support procedures, Losing the system’s setup configuration – SUPER MICRO Computer SUPER X8STE User Manual

Page 64

Advertising
background image

3-2

X8ST3-F/X8STE

User's Manual

2. Use the speaker to determine if any beep codes exist. (Refer to Appendix A

for details on beep codes.)

3. Remove all memory modules and turn on the system. (If the alarm is on, check

the specs of memory modules, reset the memory or try a different one.)

Memory Errors

1. Make sure that the DIMM modules are properly installed and fully seated in

the slots.

2. You should be using unbuffered ECC or non-ECC DDR3 (1.5V) 1333/1066/800

MHz memory (recommended by the manufacturer). Also, it is recommended
that you use the memory modules of the same type and speed for all DIMMs
in the system.

3. Check for bad DIMM modules or slots by swapping modules between slots to

see if you can locate the faulty modules.

4. Check the power supply voltage 115V/230V switch.

Losing the System’s Setup Configuration

1. Please be sure to use a high quality power supply. A poor quality power supply

may cause the system to lose the CMOS setup information. Refer to Section
1-5 for details on recommended power supplies.

2. The battery on your motherboard may be old. Check to verify that it still supplies

~3VDC. If it does not, replace it with a new one.

3. If the above steps do not fix the Setup Configuration problem, contact your

vendor for repairs.

3-2 Technical Support Procedures

Before contacting Technical Support, please make sure that you have followed all
the steps listed below. Also, Note that as a motherboard manufacturer, Supermicro
does not sell directly to end users, so it is best to first check with your distributor or
reseller for troubleshooting services. They should know of any possible problem(s)
with the specific system configuration that was sold to you.
1. Please go through the ‘Troubleshooting Procedures’ and 'Frequently Asked

Question' (FAQ) sections in this chapter or see the FAQs on our website
(

http://www.supermicro.com/support/faqs/

) before contacting Technical

Support.

2. BIOS upgrades can be downloaded from our website at

(http://www.supermicro.

Advertising
This manual is related to the following products: