SUPER MICRO Computer SUPER X8STE - Manual (Page 83)

Chapter 4: AMI BIOS
4-15
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
This feature is to enable LAN OPROM for PXE. This is to boot computers using a
network interface. The options are
Disabled and Enabled.
Load SAS Option ROM (X8ST3-F Only)
This feature is to load the Serial Attached SCSI (SAS) option ROM, if available.
The options are Disabled and
Enabled.
Boot Graphics Adapter Priority
Use this feature to select the graphics controller to be used as the primary boot
device. The options are Other,
Onboard VGA and Slot 6. Select Slot 6 if a graphics
controller is installed in the CPU-controlled Slot 6 slot.

Super IO Device Configuration
Serial Port1 Address/ Serial Port2 Address
This option specifies the base I/O port address and the Interrupt Request address
of Serial Port 1 and Serial Port 2. Select Disabled to prevent the serial port from
accessing any system resources. When this option is set to Disabled, the serial
port physically becomes unavailable. Select 3F8/IRQ4 to allow the serial port to
use 3F8 as its I/O port address and IRQ 4 for the interrupt address. The options
for Serial Port1 are Disabled,
3F8/IRQ4, 2E8/IRQ3. The options for Serial Port2 are
Disabled, 2F8/IRQ3, and 2E8/IRQ3.
Onboard Floppy Controller
Select Enabled to enable the onboard Floppy Controller. The options are
Enabled
and Disabled.
 Remote Access Configuration
Remote Access
This allows the user to enable the Remote Access feature. The options are Disabled
and
Enabled.
If Remote Access is set to Enabled, the following items will display:
Serial Port Number
This feature allows the user to decide which serial port to be used for Console
Redirection. The options are
COM 1 (Base Address 3F8h, IRQ 4), COM 2
(Base Address 2F8h, IRQ 3) and COM 3 (Base Address 3E8h, IRQ 5). An ad-