SUPER MICRO Computer SUPER X8STE - Manual (Page 84)

4-16
X8ST3-F/X8STE User’s Manual
ditional option, Onboard IPMI is featured on the X8ST3-F motherboard only, and
becomes the default.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection.
The options are
115200 8, n 1; 57600 8, n, 1; 38400 8, n, 1; 19200 8, n, 1; and
9600 8, n, 1.
Flow Control
This feature allows the user to set the flow control for Console Redirection. The
options are
None, Hardware, and Software.
Redirection After BIOS POST
Select Disabled to turn off Console Redirection after Power-On Self-Test
(POST). Select Always to keep Console Redirection active all the time after
POST. (Note: This setting may not be supported by some operating systems.)
Select Boot Loader to keep Console Redirection active during POST and Boot
Loader. The options are Disabled, Boot Loader, and
Always.
Terminal Type
This feature allows the user to select the target terminal type for Console Redi-
rection. The options are ANSI,
VT100, and VT-UTF8.
VT-UTF8 Combo Key Support
A terminal keyboard definition that provides a way to send commands from a
remote console. Available options are
Enabled and Disabled.
Sredir Memory Display Delay
This feature defines the length of time in seconds to display memory information.
The options are
No Delay, Delay 1 Sec, Delay 2 Sec, and Delay 4 Sec.

Hardware Health Configuration
This feature allows the user to monitor Hardware Health of the system and review
the status of each item when displayed.
CPU Overheat Alarm
This option allows the user to select the CPU Overheat Alarm setting which determines
when the CPU OH alarm will be activated to provide warning of possible CPU overheat.