SUPER MICRO Computer X6DHT-G - Manual (Page 23)

Chapter 2: Installation
2-3
CEK Passive Heatsink
Screw#1
Screw#2
Screw#1
1. Do not apply any thermal grease to
the heatsink or the CPU die-the required
amount has already been applied.
2. Place the heatsink on top of the CPU
so that the four mounting holes are
aligned with those on the retention
mechanism.
3. Screw in two diagonal screws (ie
the #1 and the #2 screws) until just
snug (-do not fully tighten the screws
to avoid possible damage to the CPU.)
4. Finish the installation by fully tight-
ening all four screws.
CEK Heatsink Installation
Screw#2