SUPER MICRO Computer X6DHT-G - Manual (Page 26)

2-6
X6DHT-G User's Manual
2-3 Installing DIMMs
Note: Check the Supermicro web site for recommended memory modules:
http://www.supermicro.com.
CAUTION
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage. Also note that the memory is
interleaved to improve performance (see step 1).
DIMM Installation (See Figure 2-2 on Page 2-6)
1. Insert the desired number of DIMMs into the memory slots, starting with
Bank 1. The memory scheme is interleaved so you must install two modules
at a time, beginning with Bank 1, then Bank 2, and so on.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to prevent inserting the DIMM module incor-
rectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for all modules (see step 1 above).
Memory Support
The X6DHT-G supports up to 16/32 GB Registered ECC DDR 333/266
(PC2700/PC2100) memory. All motherboards were designed to support 2GB
(DDR333)/4GB (DDR 266) modules in each slot, but has only been verified
for up to 1 GB modules.