Sierra Monitor Corporation 5100-06-IT - Manual (Page 23)

Model 5100-XX-IT Toxic Gas Sensor Module
Page: 19
5.3 MAIN MENU
Function Display Description Reference
M E
 
M E
 
M E
 
M E
 
M E
 
M E
 
M E
 
M E
 
M E
 
M E
 
M E
 
M E
 
Key
Mode Switch [M]
Enter Switch [E]
Up Switch [▲] Previous Menu
Down Switch [▼] Next Menu
5100-XX First screen at power up: Model No.
VXX-XX-- Second screen at power up: Version No.
STARTING Third screen at start up: Starting Delay
XXX PPM Normal condition - default display
Mode ALMRSET: Mode Function - Alarm Reset
Banner: "Press [E] to reset alarm"
RESET Alarm Reset
XXX PPM Default Display
Mode ALMRSET: Mode Function - Alarm Reset
Mode CALIB:-- Mode Function - Calibrate Table 6-1
Apply Selected Mode (Exit)
Mode SETUP:-- Mode Function - Set up alarms, relays, etc Table 5-3
Mode MAINT:-- Mode Function - Maintenance Table 5-4
XXX PPM Default Display (Once a minute the sensor displays module address)
Mode EXIT-?-- Exit Menu
Enter XXX PPM
Table 5-2 defines the key operational displays on the operator interface.
If display shows “Start” instead of “Starting”, the module must be calibrated before using it.
D ISPLAY D ESCRIPTION
STARTING Delay from loss of power at start-up
XXX PPM Concentration
LXXX PPM Low Alarm (Warning)
HXXX PPM High Alarm (Alarm)
Measures gas, concentration exceeds
100% of Full Scale
CXXX PPM Calibration Mode
Acknowledged Function
Table 5 - 2: Operation Display Values
Table 5 - 1: Master Menu