Sony SAT-B3 - Manual (Page 13)

13
TV With A/V Connectors Refer to the illustration below.
1
Connect the RG-6 cable from the Satellite Antenna’s LNB to the
Digital Satellite Receiver’s SATELLITE IN jack.
If your TV has only one AUDIO IN jack,
connect the lower (mono) AUDIO L jack
on the
Digital Satellite Receiver to the
TV’s AUDIO IN jack.
2
Connect the Digital Satellite Receiver’s A/V jacks to the TV’s A/V
IN jacks.
3
Connect one end of the telephone line cord to the Digital Satellite
Receiver’s TEL LINE jack. Connect the other end to your home’s
modular telephone outlet. Do not connect to a “wireless”
telephone extension. Since these devices typically do not support
high data rates, connecting to one may result in very slow
operation or may even prevent connection with your program
provider.
4
Connect one end of the AC power cord to the Digital Satellite
Receiver’s AC IN jack. Connect the plug end to an AC outlet.
Optional Connections
Your VHF/UHF IN jack may be labeled as
RF IN.
q If you have a cable input, cable box, or a terrestrial TV antenna,
connect it to the TV’s VHF/UHF IN jack.
q Best Connection : If your TV has an S-VIDEO jack, use an S-VIDEO
cable to connect the Digital Satellite Receiver’s S-VIDEO jack to the
TV’s S-VIDEO IN jack. This provides the best picture quality. Then
use audio cables to connect one set of the Digital Satellite
Receiver’s audio jacks to the TV’s AUDIO IN jacks.
q You can also connect the Digital Satellite Receiver to your audio
receiver’s AUDIO IN jacks using audio cables.
ACCESS CARD
LOW SPEED DATA
VCR CONTROL
DIGITAL
OUT
(OPTICAL)
SATELLITE IN
RF REMOTE
R L(MONO)
VIDEO OUT
AUDIO VIDEO
S VIDEO
CH3
CH4
1
2
VHF/UHF IN
VHF(SAT)/UHF
OUT TEL LINE
AC IN~
Digital Satellite Receiver
1
2
3
4
SAT-A4 receiver is pictured, but connections
are identical for SAT-B3.