Sony SAT-B3 - Manual (Page 19)

19
Setting Up the RF Antenna (SAT-A4 Only)
The RF (radio frequency) antenna enables the remote control to operate
the Digital Satellite Receiver even if the Digital Satellite Receiver is
located in another room or is placed behind a cabinet door.
Note
You must set up the RF antenna if you plan on using the RF feature.
To set up the RF antenna:
1
Connect the RF antenna to the Digital Satellite Receiver’s RF
REMOTE jack.
Do not place the RF antenna directly on
top of the Digital Satellite Receiver or any
other metal object. For best results, place
the RF antenna in a visible location.
2
Place the RF antenna at least one foot away from the Digital
Satellite Receiver.
3
Use the on-screen displays to set up the Digital Satellite Receiver to
accept RF transmission (RF ONLY). See “Setting Up the Remote
Control” on page 71 for details.
The Digital Satellite Receiver is shipped with IR transmission enabled
and RF transmission disabled. To use the RF feature, you must first
change the factory setting (IR ONLY) to the RF setting (RF ONLY)
using the on-screen displays, as described on page 71.
The operating range of the remote control
is about 100 ft. This may decrease due to
ambient radio wave conditions, your
room’s walls, weak batteries, etc.
ACCESS CARD
LOW SPEED DATA
VCR CONTROL
DIGITAL
OUT
(OPTICAL)
SATELLITE IN
RF REMOTE
R L(MONO)
VIDEO OUT
AUDIO VIDEO
S VIDEO
CH3
CH4
1
2
VHF/UHF IN
VHF(SAT)/UHF
OUT TEL LINE
AC IN~
Digital Satellite Receiver