Sony SAT-B3 - Manual (Page 81)

81
Using the Remote Control
After you’ve installed the batteries and programmed the remote
control, use these procedures to operate your system components:
The FUNCTION buttons flash to indicate
which component the remote control is set
to operate.
1
Select the component that you want to use: To operate a cable box,
TV, or the Digital Satellite Receiver, press the corresponding
FUNCTION button.
SAT-A4 Only : To operate a VCR or laserdisc player, open the lid on
the remote control and set the slide switch to the position that you
set for the component.
2
Aim the remote control at the component.
3
Press the POWER button of the component to turn it on and off.
To control other functions of the component, see the table that follows.
SAT-A4 Remote Control
Outside Panel (SAT-A4)
Note
Buttons described in the following table can operate components other than the
Digital Satellite Receiver only if you’ve programmed the remote and the
component supports the function described. See page 85 for instructions on
programming the remote.
MUTING TV
POWER
CABLE SLEEP
SAT
0
1 2
8
3
4 5 6
7 9
MENU
ENTER
GUIDE
TV/SAT TV/VIDEO
SAT TV CABLE
DISPLAY
FUNCTION
EXIT
JUMP FAVORITE
CH OFF
AUDIO POSITION SWAP PIP
SATELLITE
RECEIVER
S
CATEGORY INDEX
PAGE
+
-
RM-Y800
CH VOL
Button Operates Description
TV Mutes the volume. Press again to restore the
volume.
TV Automatically turns off the TV, after the time
period that you specify.
CABLE: Turns the cable box on and off.
TV: Turns the TV on and off.
SAT: Turns the Digital Satellite Receiver on and
off.
CABLE: Puts the remote in cable mode. In cable
mode, the remote operates your cable box.
TV: Puts the remote in TV mode. In TV mode, the
remote operates your TV.
SAT: Puts the remote in SAT receiver mode. In
SAT mode, the remote operates your Digital
Satellite Receiver. To switch from the TV to SAT
mode, press the SAT FUNCTION button, and
then press the TV/SAT button.
Only works with Sony TVs.
POSITION: Changes the PIP position.
AUDIO: Swaps the audio between PIP and the
main picture.
SWAP: Swaps the PIP picture and the main
picture.
+/–: Changes the PIP channel.
PIP: Turns PIP on.
OFF: Turns PIP off.
MUTING
SLEEP
TV
POWER
CABLE
SAT
SAT TV CABLE FUNCTION
CH OFF
AUDIO POSITION SWAP PIP
+
-