Barricade setup using windows, Software installation, Using the barricade utility – SMC Networks Barricade User Manual
Page 11
Page 8
Barricade Setup using Windows
♦
For basic operation, only the following setup is required.
♦
For the full range of options available to the Network Administrator, refer to
Chapter 3 - Administration.
Software Installation
1.
Insert the supplied CD-ROM into the drive of your Windows 95/98/ME or
Windows NT4.0/2000 system.
2.
If the Setup program does not start, run SETUP.EXE in the root directory.
3.
Click the Barricade Utility button.
4.
Follow the prompts to install the Barricade Utility.
Using the Barricade Utility
1.
Start the program. Normally, the program will start immediately after installa-
tion. Otherwise, use the Start Menu option created by the installation.
2.
The screen will look like the example below. The left section displays a list of
all Barricades. The right section displays data about the currently-selected Bar-
ricade. (If no Barricades are listed, see the Troubleshooting section.)
Figure 2: Barricade Utility
3.
Ensure that the desired Barricade is selected in the left panel, then click the
Setup Wizard icon.
6HWXS:L]DUG