SMC Networks Barricade - Manual (Page 12)

Page 9
4. If you are prompted for a User Name and Password, enter admin for the user
name, and the password you have assigned to the admin user (By default, there
is no password, so the Password field can be left blank.)
5. The Setup Wizard will then start. Step through the Wizard and complete each
screen. The following data will be required:
Server
Server Name: The Default Name is shown. Change this if you wish.
Comment: Comments (e.g. Location of the Barricade) are op-
tional.
Time Zone Select your time zone from the list.
Date/Time Enter the local date (mm/dd/yyyy format) and time.
Microsoft Networking
Workgroup Name: Normally, this name should match the Workgroup
name used by PCs on your LAN.
WINS If your LAN has a WINS (Windows Internet Naming
Service) Server, check the box and enter the IP Ad-
dress of the WINS Server.
TCP/IP
Obtain an IP Address
automatically
(DHCP Client) If you have a DHCP or Bootp server on your LAN,
you can enable this setting. The Barricade will then
obtain its IP Address from the DHCP or Bootp
server.
However, because this is a Server, it is preferable to
use a Fixed IP Address.
Also, the "DHCP Client" setting will disable
Internet Access via the Barricade.
If your LAN does not have a DHCP server, then you
must select Fixed IP Address.
Fixed IP Address: This option is required if you wish to use the DHCP
Server function. It is also necessary to allow the
Barricade to act as an Internet Gateway, providing
shared Internet access to LAN clients.

6HOHFWLQJ'+&3
&OLHQWZLOOGLVDEOH
,QWHUQHW$FFHVVYLD
WKH%DUULFDGH