Sony MVS8000SF-C - Manual (Page 38)

1-30
MVS-8000SF
A B C D E F G H J K L M N P R
TP1
D1
TP9501
D9551
D9051
TP9001 E1
S101
S1
E6
E7
D401
CN101
TP3001 TP3501 TP8001 TP4001 TP4501 TP5001
TP5501
E3
E2
TP2501 TP2001 TP1001 TP1501 TP7001 TP7501 TP6501 TP6001
1
2
3
4
5
6
7
8
9
10
11
12
13
DI-43 board A side/Component side
..... DI-43 board
<LED>
D1 (A-3) :
+ + + + +12 V
+12 V power supply status indication.
Lit when the
+12 V power is supplied.
If this LED does not light, the fuse may have blown.
D401 (A-6) : CONF ERR status LED
FPGA (EP20K100E) CONFIG DONE status indication.
Not lit when all configurations are completed.
D9051 (A-5) : + + + + +1.8 V
+1.8 V power supply status indication.
Lit when the
+1.8 V power is supplied.
D9551 (A-4) : + + + + +3.3 V
+3.3 V power supply status indication.
Lit when the
+3.3 V power is supplied.
<Switch>
S1 (A-7) : DI reset switch
Pressing this switch initializes the DI-43 board.
S101 (A-8) : JTAG switch
Used only for production in the assembly factory. Set this
switch to ON only when writing program in the JTAG
device with ISP.
<Connector>
CN101 (A-8) : ISP common connector
Used only for production in the assembly factory. Used for
program writing into the JTAG device with ISP.
<TEST terminal>
E1 (C-5), E2 (J-2), E3 (N-3), E4 (C-11), E5 (H-11), E6 (N-10),
E7 (A-6) : GND terminal
Use this terminal as the earth point for measuring the
respective check terminals.
1-8. Checks on Completion of Installation