Sony MVS8000SF-C - Manual (Page 60)

1-52
MVS-8000SF
1-8. Checks on Completion of Installation
<LED>
D1, D2, D3 (A-6) : MY-CPU status LED
Status indication of the CPU on the MY-102 board.
D201 (A-5) : + + + + +12 V
+12 V power supply status indication.
Lit when the
+12 V power is supplied.
If this LED does not light, the fuse may have blown.
D202 (A-5) : + + + + +3.3 V
+3.3 V power supply status indication.
Lit when the
+3.3 V power is supplied.
D203 (A-5) : + + + + +1.8 V
+1.8 V power supply status indication.
Lit when the
+1.8 V power is supplied.
10. MY-102 board (MKS-8440HD/SD/M)
A B C D E F G H J K L M N P R
1
2
3
4
5
6
7
8
9
10
11
12
13
D3
D2
D1
S202
D201
D202
D203
S201
CN12
CN14
E121
E124
E132
E131 TP706 TP705
TP704
TP904
TP905 TP906
E123
TP203
TP204
E122
E129
E508
TP504
TP507
TP505
TP506
E601
E801
E1001
E130
G F E D C B A
654321
D12
D18
D19
D10
D13
D14
D15
D16
D17
SW2
SW1
CPU-DR
Module
A side/Component side
<Switch>
S201 (A-5) : MY-CPU reset switch
Pressing this switch initializes the CPU on the MY-102
board.
S202 (A-5) : MONITOR reset switch
The reset switch that is used to reset the monitor during
maintenance through the terminal.
<Connector>
CN12 (A-8) : ISP common connector
Used only for production in the assembly factory. Used for
program writing into the JTAG device with ISP.
CN14 (A-7) : TERMINAL pin
This pin is connected to the CPU control terminal and used
during maintenance.
Conforms to RS-232C.