Sony STR-DA9000ES - Manual (Page 20)

masterpage:Left
filename[\\Nas-data-server\sony current jobs\SONY STR-DA9000ES\DTP\STR-DA9000ES
GB\GB03CON_STR-DA9000ES-U.fm]
20 GB
model name1[STR-DA9000ES]
[4-249-349-11(1)]
Connect the supplied AC power cord to the AC
IN terminal on the receiver, then connect the AC
power cord to a wall outlet.
Notes
• The AC OUTLET(s) on the rear of the receiver is a
switched outlet, which supplies power to the
connected component only while the receiver is
turned on.
• Make sure that the total power consumption of the
component(s) connected to the receiver’s AC
OUTLET(s) does not exceed the wattage stated on
the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons,
fans, or TVs to this outlet. This may cause a
malfunction.
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure.
This procedure can also be used to return
settings you have made to their factory defaults.
1
Press ?/1 to turn off the receiver.
2
Hold down ?/1 for 5 seconds after
pressing MEMORY/ENTER.
“ENTER to Clear ALL” appears in the
display for 10 seconds.
3
Press MEMORY/ENTER while “ENTER
to Clear ALL” appears in the display.
After “MEMORY CLEARING...” appears
in the display for a while, “MEMORY
CLEARED!” appears.
The following are reset to their factory
settings.
• All settings in the SPEAKER SET UP,
LEVEL, SURR SET UP, EQUALIZER,
and CUSTOMIZE, CIS, TUNER menus.
• The sound field memorized for each
input
• All index names for inputs.
Note
If “2nd zone on” or “3rd zone on” appears in the
display, the initial setup operation cannot be
performed. Turn off the indication by following the
first tip of “Listening to the sound in another zone”
(page 52).
4: Connecting the AC
power cord
A
B B
A
R L
R L
SURROUND BACK
SURROUND
FRONT
IMPEDANCE USE 4-16 A+B USE 8-16
CENTER
AC OUTLET
A
B B
A
R L
SPEAKERS AC IN
AC OUTLET
AC IN
terminal
AC power cord