Sony STR-DA9000ES - Manual (Page 60)

masterpage:Left
filename[\\Nas-data-server\sony current jobs\SONY STR-DA9000ES\DTP\STR-DA9000ES
GB\GB08ADD_STR-DA9000ES-U.fm]
60 GB
model name1[STR-DA9000ES]
[4-249-349-11(1)]
• Replace all the batteries in the remote with new
ones, if they are weak.
• Check if the command modes of the receiver and
the remote is the same. If the command mode of
the receiver and the remote is different, you
cannot operate the receiver with the remote.
To switch the command mode of the remote, press
?/1 while pressing INPUT MODE. Each time
you press ?/1, the command mode switches
between “C.MODE. AV2” and “C.MODE. AV1”.
(The initial setting is “C.MODE. AV2”.)
• Make sure you select the correct input on the
remote.
Error messages
If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
01/DECODE ERROR
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when “DEC.
PRIORITY” in the CUSTOMIZE menu is set to
“PCM”. Set to “AUTO”.
11/PROTECTOR
Irregular current is output from the speakers. Turn
off the receiver, check the speaker connection and
turn on the power again.
12/PROTECTOR
The receiver section is overheated. Check that the
ventilation hole is not covered. Turn off the
receiver, leave the receiver for a while and turn on
the power again.
13/PROTECTOR
The power section is overheated. Check that the
ventilation hole is not covered. Turn off the
receiver, leave the receiver for a while and turn on
the power again.
21/PROTECTOR
Turn off the receiver and consult your nearest Sony
dealer.
71/PROHIBITED
The receiver cannot output the sound due to the
copyright protection.
72/UNKNOWN SIGNAL
The receiver is not compatible with the format of the
input signal.
Reference sections for clearing
the memory
To clear See
All memorized settings page 20
Customized sound fields page 39