Sony STR-DA9000ES - Manual (Page 56)

masterpage:Left
filename[\\Nas-data-server\sony current jobs\SONY STR-DA9000ES\DTP\STR-DA9000ES
GB\GB070TH_STR-DA9000ES-U.fm]
56 GB
model name1[STR-DA9000ES]
[4-249-349-11(1)]
If you have the i.LINK component SCD-
XA9000ES, connect to this receiver with an
i.LINK cable (supplied with SCD-XA9000ES).
This receiver is compatible with the i.LINK
connection with SCD-XA9000ES only. The
i.LINK connection to SCD-XA9000ES through
other component, and i.LINK connection to
other component are not guaranteed.
Notes
• If a metal object should fall into the i.LINK jack,
short-circuiting may occur and damage the
components.
• Be sure to insert the plug firmly to prevent
malfunction.
• About the compatible signals, see page 61. This
receiver cannot deal with incompatible signals such
as DV, MICROMV, or MPEG-TS. Some i.LINK
components conforms to copy protection technology
and deals with encrypted signals. This receiver
conforms to the copy protection technology of
DTLA (Revision 1.2).
• Sound fields and LIP SYNC function (page 41) are
not activated when DSD signals is input to this
receiver.
Establishing a LINC
Before an audio signal can be transmitted
between i.LINK components, a LINC (Logical
INterface Connection) must first be established
between the receiving component (of the audio
signal) and the sending component. Establishing
a LINC means establishing a logical path for the
transmission of digital audio signals between the
two components. Each logical path has an ID
number. Since the component that sends an
audio signal must output the signal to a path, and
the component that receives the signal must
input it from the same path, the path must be
mutually known by both components. During
the establishment of a LINC, the following
communication occurs between the two i.LINK
components.
Example
This receiver establishes a LINC with SCD-
XA9000ES.
1 This receiver sends a request and path information
to SCD-XA9000ES to establish a transmission path
for the audio signal.
2 SCD-XA9000ES responds to the component,
agreeing to the establishment of a LINC.
The digital audio signal transmission becomes possible
only after the communication described above has
occurred and a LINC has been established.
Notes
The LINC is cancelled in the following cases.
– When i.LINK cable is connected or disconnected.
– When the input selection is switched.
i.LINK connection
1
,
2
<
STR-
DA9000ES
SCD-XA9000ES