Jiaye General Merchandise Co BTP-M280 - Manual (Page 16)

BTP-M280 User’s Manual
- 12 -
4.4 Connecting the Power Adapter
1) With the flat side of the power adapter’s cable connector facing
downward, insert the cable connector into the power connector on the
backside of the printer.
2) Turn on the input power source of the adaptor.
Caution：
— Use only the supplied power adapter or other equal model.
— When connecting or disconnecting cable connector of the power adapter, you should pull on the
connector, not pull on the cable by force.
— Do not pull on the power adapter cord. Otherwise the cord may be damaged or broken, causing a
risk of fire or electric shock.
— Do not place the power adapter cord near a heating device, otherwise, the cover of the cord may
melt, causing a risk of fire or electric shock.
— When the printer is not used for a long period of time, disconnect the power adapter from the wall
outlet for safety.
4.5 Connecting USB signal cable
1) Ensure the printer is turned off.
2) As shown the figure below, put the USB signal cable into the suitable
USB interface.
3) Connect other end of USB signal cable to host.
4.6 Connecting optional signal cable
1) Turned off the printer.
2) Put the signal cable into suitable connector and fix it with plug screw (or
clip spring).
3) Connect other end of the signal cable to host.
4.7 Connecting the Cash Drawer
1） Turned off the printer.
2） Insert the cash drawer cable into the cash drawer connector on the
backside of the printer.
Caution：
— Do not connect a telephone line to the cash drawer connector; otherwise the printer and the
telephone line may be damaged.
4.8 Installing Ribbon
1) Ensure that ribbon type is standard ERC-38.
2) Open front cover of the printer as shown.