Sony BBV RX100 - Manual (Page 7)

Rx100 installation manual V1.17 29 Aug 08.doc Page 7
CABLE CONNECTION METHOD
Fig. 1: cage clamp connectors
The cage clamp PCB terminal block is a simple-to-use method of
attaching cables to PCBs quickly and easily. Prepare cables as
follows:
•
Use only cable between 0.08 and 2.5 mm²
•
Strip the cable to a length of 5 to 6 mm (0.23 in)
The correct method of attachment is as follows:
1. Press down the relevant terminal block lever with a suitable
screwdriver;
2. Insert wire;
3. Remove screwdriver.
The procedure for detaching wires is the reverse of the 3 attachment
steps, ensuring that power is disconnected before starting.
CABLING RECOMMENDATIONS FOR THE Rx100 INTERFACE.
Although BBV do not specify any particular type, manufacturer or supplier of cables, the following ESD
Electronic Services (01279 626777) cables have been used successfully for production and testing:
ESD Part Number:
Description:
0222586G Coax Cable (Minimum Specification)
(100 m)
RG59B/U ESD radio frequency coax cable to BS2316 and MIL-C-17
1/0.58mm copper-covered steel wire conductor with solid polythene dielectric, bare
copper wire braid and PVC sheath
Characteristic impedance: 75 Ohm
Capacitance: 22pF/ft
020966D Orange-Coloured Lighting Output Power Cable (1000 w)
(100 m)
3183Y PVC-insulated, 3-core cable
1.25mm ² 40/0.2mm annealed copper conductor
Current rating: 13 amp
0140467H 20mA Twisted Pair Cable (Minimum Specification)
(100 m)
British Telecom spec CW 1308
2-core 1/0.5mm PVC-insulated
Maximum conductor resistance at 20 degrees Celsius: 97.8 ohms/km