Sagem 4450E - Manual (Page 117)

SAGEM 3P@C
3P@C Installation Manual
Page 7-2 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
1.1.1.51 1.1.1.51 1.1.1.51 1.1.1.51 Upgrade through BOOTROM
During code start, you can download the system software to the hard disc or mobile storage equipment.
During the power-on, the BOOTROM menu prompts you to upgrade the system software in two ways: Upgrade
through network ports, and upgrade through the Console port.
Normally, you are suggested to upgrade the
system file through the network port. It is because the system software is large, while the download speed
through the Console port is very low.
1.1.1.51.1 Upgrade the system software through the network port
Step 1: Set the FTP server remotely
In this mode, you need to establish an FTP server in the terminal storing the program file, connect the equipment
to be upgraded with the FTP server through the specified port, and establish a user name and password in the
FTP server.
prompt
SAGEM sa does not provide the FTP software, so users need to
prepare or purchase such software. The 3CDaemon software of
3COM is recommended.
Step 2: Enter the main menu of the Bootrom
During equipment start, press and hold <Space> to enter the main menu of the Bootrom as follows:
3P@C 4450E Boot Loader V2.21
Compiled: Jan 3 2004 13:21:04
SDRAM test....passed.
Base ethernet MAC address: 00:05:3b:48:47:fd
? - List all available commands
h - List all available commands
g - Boot an executable image
dl - Enter download mode to load new image or config file
r - Reboot system
Press 'h' or '?' To get helping information.
3P@C: