Sagem 4450E - Manual (Page 150)

SAGEM 3P@C
3P@C Installation Manual
Page 9-9 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Steps Operation Inspection (display of the
indicator and screen)
Step 5 To check the running status of the
service board, execute the
command show version all or
show boardinfo. The system indicator flashes
normally.
If the type of the new card is the same as that of the original card, check whether the service on the interface of
the new card is recovered. If the type of the new card is different from that of the original card, you should
configure the service on the new card.