Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 2000592-001 - Manual (Page 26)

DataNET Fiber Optic Connections
The Fiber Optic Coupler is mounted in a threaded, potted, gas tight fitting
assembly designed for use in hazadrous areas when properly installed in
a approved enclosure. Two Fiber Optic Couplers are required, one for
DataNET Channel A and one for DataNET Channel B. The couplers are
mounted through pre-drilled holes located in the top or side of the wiring
acess plates or safety box. Description
Required Parts All mounting hardware is supplied with the DataNET Fiber Optic parts kit.
These parts are also available as spares and can be ordered from us.
Description Part Number
Fiber Optic Coupler Assembly 2015828-001
Fiber Optics Coupler Seal Nut N8005
Fiber Optic Coupler Cable 2020947-0011
Electrical/Mechanical
Description
The DataNET Fiber Optic Coupler performs translation of signals
between a DataNET Hub and Advance Maxum. The Fiber Optic Coupler
converts between electrical signals and optical signals. The conversion is
transparent to the network. Fiber Optic signals are impervious to
distubances caused by electrical interference from nearby equipment,
ground loops, power surges, or nearby lightning strikes.
DataNET Fiber Optics Couplers can drive up to 5000 feet of fiber optic
cable.
16
• Installation
2000592-001