Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 2000592-001 - Manual (Page 52)

Command Descriptions, Continued
login The login command allows the user to access all the ANCB parameters
and diagnostic information. The format is:
login password Where password is the user password.
A password can contain any alphanumeric character and must be
between 5 and 20 characters in length. See the password command for
information on how to change the user password.
Users can login to a remote ANCB or DataNET HUB by first logging out
of the local device and then typing:
login password xxx.xxx.xxx.xxx Where xxx.xxx.xxx.xxx is the IP
address of the remote device.
logout The logout command is used to log the user out of either the local or
remote device. Note: User’s will be automatically logged out after five
minutes of non-activity unless the user has issued the timeout off
command. Also the user must be logout of the local device before
logging into a remote device. See the login command.
netstat This command is used to display statistics for the DataNET, Ethernet, or
OS memory buffers.
The command netstat hdlc displays the total statistics for all DataNET
ports.
The command netstat hdlc1 displays the statistics for DataNET port
one only.
42
• Command Summary
2000592-001