Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 2000592-001 - Manual (Page 43)

Firmware Updates
Description Periodically we will provide our users with firmware upgrades. Perform
the following instructions to download a new firmware upgrade to the
Communications board ANCB. A firmware upgrade will take
approximately 5 minutes.
Instructions The following procedure assumes that the HyperTerminal program is
residing on your PC and has been configured.
1. Connect a standard 9-pin COM cable from the PC COM port to
RS232 connector located on the ANCB/DN board.
2. Open HyperTerminal program on your PC; reference Configuring
Your PC, page 22.
3. Connect and Log on to the Maxum.
4. At the
> prompt type: download
You should see the following response on the screen. At this point
the ANCB is ready to receive the new firmware version.
5. From the Main Menu bar click on Transfer.
2000592-001 Data Communications Setup
• 33