Samsung DSR-1/1P - Manual (Page 41)

Chapter 3 Shooting
Chapter 3 Shooting
41
4
Display menu 212 and select the audio recording mode (two-channel
mode or four-channel mode).
For menu operation, see “Selecting Audio Recording Mode — Menu 212”
(page 67).
Note
If you should switch audio modes during recording, the recordings at
switching points prevent editing. Avoid changing the audio mode once
you have started recording. One of the following warning indicators
appears in the display area when you change the audio mode setting.
5
Set up the camera to suit your recording objectives, and press the VTR
button on the camera or lens.
For details on camera setup, see your camera’s operating instructions.
Recording begins when the TALLY indicator stays lit after blinking
for a moment.
During recording, the tape transport buttons (EJECT, REW, F FWD,
PLAY, and STOP) cannot be used.
Note
The DSR-1/1P stops recording if you turn the camera’s power switch
off during recording. This causes the DSR-1/1P’s WARNING
indicator to light, and the warning tone is emitted. At the same time,
the REC/TALLY indicator(s) blink(s) in the viewfinder.
Warning indication Status
Fs 48K (flashes four times
per second) Attempting to switch from 32-kHz mode (four-
channel mode) to 48-kHz mode (two-channel
mode)
Fs 32K (flashes four times
per second) Attempting to switch from 48-kHz mode (two-
channel mode) to 32-kHz mode (four-channel
mode).
Operation Step
To view image
being shot • Look into the viewfinder.
• Connect a video monitor to the VIDEO OUT connector or
S VIDEO OUT connector.
To listen to audio
track being shot. Connect an earphone to the EARPHONE connector
or listen to the audio from the speaker.
To pause recording Press the VTR button on the camera or lens.
For instructions on continuing to record after a pause, see
“Back Space Editing” (page 43).
To stop recording Press the VTR button on the camera or lens, then press the
STOP button on the DSR-1/1P.
With this state, it is impossible to start back space editing.
To remove the
cassette Check that the power is on, then press the EJECT button to
open the cassette holder and remove the cassette. Close
the cassette holder.