Samsung DSR-1/1P - Manual (Page 50)

Chapter 4 Time Values
50
Chapter 4 Time Values
You can set the user bits as eight-digit hexadecimal
values (base 16) to have the date, time, scene number,
and other information inserted into the time code.
When using both the time code and user bits, set up the
user bits first. If you set the time code first, the internal
time code generator will remain stopped while you set
the user bits, which will set the time value off from the
original setting.
Setting the User Bit Value
Note
Setting the user bit value may be disallowed in some
cases at ClipLink shooting. For details, see step
4 on
page 56 in Chapter 5 “ClipLink Shooting”
1
Set the DISPLAY switch to U-BIT.
The user bits indication appears.
2
Set the TC mode switch 1 to PRESET.
3
Set the TC mode switch 2 to SET.
This causes the leftmost digit in the user bits
indication to start blinking.
4
Set the user bits.
Hexadecimal digits A to F are displayed as
follows.
5
Perform step 6 in “Setting the Time Code Value”
on page 52.
Operation Step
Select a
digit Press the SHIFT button.
Each time you press the SHIFT button,
the next digit to the right starts blinking.
Change a
value Press the ADVANCE button.
Each time you press the ADVANCE
button, the displayed value is
incremented to F and returns to 0.
Reset Press the RESET/(MENU SET) button.
The display returns to “00 00 00 00”.
∞
1
dB
2
PB DATE NDF EXT-LK HOLD
CLIP
TAPE
BATT
DIAG
E F
RF SERVO HUMID SLACK
Li -
-40
-30
-12
0
IP CL CONT
OVER OVER WARNING
RESET
(MENU SET)
MENU ADVANCE SHIFT
ALARM
MONITOR
PRESET
DATE/TIME
ClipLink CONTINUE
MONITOR SELECT
BACK TALLY
LIGHT
DISPLAY
AUDIO LEVEL
AUDIO SELECT
AUDIO IN
CH-2
CH-1
OFF ON
MIX REGEN SET
F-RUN
R-RUN
AUTO
MANUAL
CAM
REAR
ON
OFF
COUNTER
TC
U-BIT
CH-1 CH-2
-20
DVCAM
F 8 32k F 8 48k
2 3
1
4
Hexadecimal digit A B C D E F
Display A b C d E F