Samsung DSR-1/1P - Manual (Page 58)

Chapter 5 ClipLink Shooting
58
Chapter 5 ClipLink Shooting
During recording pause in ClipLink mode, pressing the
STOP/PLAY/F FWD/REW buttons, performing edit
search (with the DXC-D30/D30P/D35/D35P), or
ejecting the cassette will interrupt the ClipLink
shooting. With this state, it is impossible to start back
space editing using ClipLink function. (The ClipLink
continue mode is canceled and indication
CONT in the
display window disappears.) If you resume recording
on the same cassette, the previously recorded data will
be overwritten.
Resuming Recording in ClipLink Mode
You can avoid this and continue recording in ClipLink
mode from the previous recording stop point by
performing the following steps.
Note
If you stop recording during the first ten seconds of
recording, you may not be able to use these steps to
continue recording in ClipLink mode.
1
Perform step 1 (page 38) in Chapter 3 “Shooting”.
2
Insert a cassette if one is not already loaded.
The
CL
and indications should appear in the
display window.
Note
If the
CL
is flashing, it means abnormality of the
cassette memory. In this case, it is impossible to
continue recording from that data on ClipLink
mode.
3
Check the following points.
4
Press the ClipLink CONTINUE button.
The tape remaining indication in the display
window flashes as the DSR-1/1P automatically
searches the recording stop point. When it finds
the recording stop point, it stops and enters
recording pause mode.
Once it has stopped, check that the
CONT indicator
appears in the display window.
To find the recording stop point efficiently
If you press the ClipLink CONTINUE button
after rewinding or fast forwarding the tape to the
position between the previous recording’s start
point and stop points, the recording stop point can
more efficiently be found via an automatic search
function.
Note
Do not turn the camera’s power switch on or off
while the DSR-1/1P is searching for the recording
stop point, as it might disable the search function.
If, for this or another reason, the recording stop
point cannot be found, the
CONT indicator flashes
in the display window.
Result and response
If these indications do not appear in the
display window, access the VTR menu
and set ClipLink function to on (see
page 67).
Make sure there are enough capacity for
recording index pictures (see page 13).
CLIP and IP
appear in
the display
window
Remaining
clips
Check point
1,2,3
2
4