Samsung DSR-1/1P - Manual (Page 43)

Chapter 3 Shooting
Chapter 3 Shooting
43
This section describes the steps for recording several scenes continuously.
If using the DSR-1/1P with the DXC-D30/D30P/D35/D35P, you can also perform
back space editing while creating clips. For details, see Chapter 5 “ClipLink
Shooting”.
1
Follow steps 1 to 5 (pages 38 to 41) in the procedure “Shooting” to
begin recording.
To continue the time code that has been recorded on the tape, set the
TC mode switch 2 to R-RUN in step
3 (page 40).
For details of time codes, see “Setting Time Code Value” on page 51.
2
When you have finished recording a scene, press the VTR button on
the camera or lens.
This pauses the recording operation.
Note
Do not do any of the following before the next scene is shot as it
will interrupt the recording (the recording will not be continuous).
• Remove the cassette.
• Transport the tape (play, rewind, fast forward).
• Press the STOP button.
• Replace the battery when the DSR-1/1P is powered.
3
When you are ready to shoot the next scene, again press the VTR
button on the camera or lens.
This restarts the recording operation.
4
Repeat steps 2 and 3 for each scene to be shot.
Back Space Editing
Operation Step
Restart an interrupted
recording
(see step 2 above) See “Starting Back Space Editing at Any Tape
Position” on next page.
Check the recorded contents See “Checking the Record Contents
Immediately After Shooting —Recording
Review” on page 47.
Stop recording Press the VTR button on the camera or lens,
then press the STOP button on the DSR-1/1P.