Samsung DSR-1/1P - Manual (Page 55)

Chapter 5 ClipLink Shooting
Chapter 5 ClipLink Shooting
55
Recording Using ClipLink Function
Chapter 5 ClipLink Shooting
The ClipLink function is intended to be used at various
stages from recording to editing. When you record
using this function, index pictures are automatically
recorded along with the time code, scene number, and
other data, all of which make for more efficient
editing. For an overview of the ClipLink function, refer to the
supplied “ClipLink™ Guide”.
1
Perform the first two steps (pages 38 to 40) in the
Chapter 3 “Shooting”. Check the following points.
CLIP and IP appear in the display window.
Notes
• If you use a cassette that contains data recorded
via a different VCR (not the DSR-1/1P), when
you enter a cassette name/number in the cassette
Method
See “Selecting the
ClipLink Function —Menu
211” under Chapter 6
“Menu” (page 67).
Check point
Check the ClipLink
function is on (or set it to
on).
Check whether or not the
cassette includes cassette
memory. (The DSR-1/1P
supports cassettes with up
to 16 Kbits of cassette
memory.) appears in the display
window when the loaded
cassette includes cassette
memory. (The ClipLink
function cannot be used
unless
appears in the
display window.)
2
∞
H MIN SEC FRM
1
dB
2
PB DATE NDF EXT-LK HOLD
CLIP
TAPE
BATT
DIAG
E F
RF SERVO HUMID SLACK
Li -
-40
-30
-12
0
IP CL CONT
OVER OVER WARNING
RESET
(MENU SET)
MENU ADVANCE SHIFT
ALARM
MONITOR
PRESET
DATE/TIME
ClipLink CONTINUE
MONITOR SELECT
BACK TALLY
LIGHT
DISPLAY
AUDIO LEVEL
AUDIO SELECT
AUDIO IN
CH-2
CH-1
OFF ON
MIX REGEN SET
F-RUN
R-RUN
AUTO
MANUAL
CAM
REAR
ON
OFF
COUNTER
TC
U-BIT
CH-1 CH-2
-20
DVCAM
F 8 32k
F 8 48k
1,2
1
3
Make sure that the lithium
battery has been correctly
inserted and is not used
up. Li appears in the display
window if the lithium
battery has not been
inserted or is used up.
Display Meaning
CLIP The DSR-1/1P is in ClipLink mode.
IP The DSR-1/1P is in ClipLink mode and can
record index pictures.
memory, you may lose any data that was
previously written to the cassette memory. Also,
if you use a cassette that contains data recorded in
ClipLink mode on the DSR-1/1P for recording on
a different VCR, you may lose any data that was
previously written to the cassette memory.
• When you power the DSR-1/1P or insert a
cassette, black squares ( p) blink in the place of
the clip remaining indication in the display
window (during this, the cassette memory data is
being checked). Start recording after the blinking
ends, or the ClipLink function will be disabled.
• When
CL
appears in the display window, it
means that data has already been recorded into
the cassette memory. If you record under this
condition whether the ClipLink function is
available or not, the existing cassette memory
data will be overwritten. To avoid this, you can
either insert a new cassette or follow the
procedure for appending cassette memory data, as
described in the section “Resuming Recording in
ClipLink Mode” (page 58). If the
CL
is flashing,
it means abnormality of the cassette memory. In
this case, it is impossible to continue recording
from that data on ClipLink mode.
(Continued)