SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 70)

C
ONFIGURING THE
S
WITCH
3-20
Using DHCP/BOOTP
If your network provides DHCP/BOOTP services, you can configure the
switch to be dynamically configured by these services.
Web – Click System, IP Configuration. Specify the Management VLAN,
set the IP Address Mode to DHCP or BOOTP. Then click Apply to save
your changes. The switch will broadcast a request for IP configuration
settings on the next power reset. Otherwise, you can click Restart DHCP
to immediately request a new address.
Figure 3-7 IP Configuration
Note: If you lose your management connection, use a console
connection and enter “show ip interface” to determine the new
switch address.