Sherwood R-771 - Manual (Page 10)

ENGLISH
9
6. CONNECTING SYSTEM CONTROL
• Connect this jack to the DIGI LINK jack of the external
Sherwood component that uses the DIGI LINK II or III
remote control system.
7. SUBWOOFER PREOUT connection
• To emphasize the deep bass sounds, connect a powered
subwoofer.
8. CONNECTING SPEAKERS
• Be sure to connect speakers firmly and correctly according
to the channel(left and right) and the polarity(+ and -). If the
connections are faulty, no sound will be heard from the
speakers, and if the polarity of the speaker connection is
incorrect, the sound will be unnatural and lack bass.
• For installing the speakers, refer to "Speaker placement" on
page 10.
• After installing the speakers, first adjust the speaker settings
according to your environment and speaker layout.(For
details, refer to "SETTING THE SPEAKER / ROOM EQ
SETUP" on page 43.)
Surround back speakers
• When using only one surround back speaker, you should
connect it to SURROUND BACK/ROOM 2 LEFT channel.
• If you assign the power amplifier for the surround back/
room 2 channels to the ROOM 2, this unit can drive the
speakers in another room (ROOM 2).
(For details, refer to "CONNECTING ROOM 2 OUTs" on
page 11 and "When selecting the AMP ASSIGN" on page
37.)
Caution :
• Be sure to use the speakers with the impedance of 6 ohms
or above.
• Do not let the bare speaker wires touch each other or any
metal part of this unit. This could damage this unit and/or
the speakers.