Sherwood R-771 - Manual (Page 48)

ENGLISH
47
Repeat the above steps and until the distances are all set as desired.
4
When selecting the desired unit
• You can select either METER or FEET.
• Once a unit is selected, the distances are
automatically changed in the selected unit.
When setting the distance
• You can set the distance within the range of 0.1 ~
9.0 meters in 0.1 meter intervals (or 0 ~ 30 feet in
0.5 feet intervals).
Press the CURSOR LEFT( )/RIGHT( ) buttons to set the selected item as desired.
3
Press the CURSOR UP( )/DOWN( ) buttons to select the SPEAKER DISTANCE, then
press the ENTER button.
1
When selecting the SPEAKER DISTANCE
Press the CURSOR UP( )/DOWN( ) buttons to select the desired item.
2
Note :
• You cannot select the speakers set to "NONE".
About the speaker distance
When enjoying multi-channel surround playback with Dolby Digital and DTS sources, etc., it is ideal that the
center, surround and surround back speakers, etc. should be the same distance from the main listening
position as the front speakers. By entering the distance between the listening position and each speaker, the
delay times of center, surround and surround back speakers, etc. are automatically adjusted to create an
ideal listening environment virtually as if the center, surround and surround back speakers, etc.were at their
ideal locations respectively.
ENTER ENTER
CH.LEVEL CH.LEVEL
CHANNEL CHANNEL
ENTER ENTER
CH.LEVEL CH.LEVEL
CHANNEL CHANNEL