Sherwood R-771 User Manual

Page 38

Advertising
background image

Press the CURSOR UP(

)/DOWN(

) buttons to select the desired item.

1

Press the CURSOR LEFT(

)/RIGHT(

) buttons to set the selected item as desired.

2

• AMP ASSIGN : To assign the surround back channel's power

amplifier to ROOM 2 for ROOM 2 playbak.

• OUT ASSIGN : To assign the ROOM 2/TAPE OUTs to TAPE

REC for analog audio recording.

• SUBWOOFER MODE : To select the desired subwoofer mode.
• TONE CONTROL : To adjust the tone (bass and treble) as

desired.

• CINEMA EQ : To select the desired cinema EQ mode.
• MOMENTARY OSD : To turn on or off the OSD that shows the

status corresponding to each operation
momentarily.

• OSD POSITION ADJUST : To adjust the positon of the

momentary OSD and the OSD menu.

SETTING THE SYSTEM SETUP

When selecting the items other than OSD POSITION ADJUST

• You should assign the power amplifier for the surround back/room 2 channels to ROOM 2 when the

SURROUND BACK/ROOM 2 speaker terminals are connected to the speakers installed in another room
for ROOM 2 playback. In this case, you need not use the power amplifier to drive the speakers
additionally. (For details on ROOM 2 connection, refer to "CONNECTING ROOM 2 OUTs" on page 11.)

SURR BACK : To use power amplifier for the surround back channels.

ROOM 2 : To use it for ROOM 2 playback.

Note : When the EXTERNAL IN is selected as a main source, the AMP ASSIGN is automatically set to

"SURR BACK".

ENTER

ENTER

CH.LEVEL

CH.LEVEL

CHANNEL

CHANNEL

ENTER

ENTER

CH.LEVEL

CH.LEVEL

CHANNEL

CHANNEL

When selecting the AMP ASSIGN

• Depending on how to use the ROOM 2/TAPE OUTs, you should assign these to ROOM 2 or TAPE REC.

ROOM 2 : To use the ROOM 2/TAPE OUTs for ROOM 2 playback

(For details on ROOM 2 connection, refer to "CONNECTING ROOM 2 OUTs" on page 11.)

TAPE REC : To use them for analog audio recording.

(For details on connection, refer to "CONNECTING AUDIO COMPONENTS" on page 8.)

Note : When the AMP ASSIGN is set to "ROOM 2" or the ROOM 2 mode is turned on, the OUT ASSIGN is

automatically set to "ROOM 2".

When selecting the OUT ASSIGN

37

ENGLISH

Advertising