Sony DVP NC555ES - Manual (Page 68)

68
Controlling the volume of your
AV amplifier (receiver) with the
remote
1
Slide the TV/DVD switch to DVD.
2
Hold down [/1, and enter your AV
amplifier (receiver)’s manufacturer’s
code (see the table below) using the
number buttons.
3
Release [/1.
The VOL +/– buttons control the AV
amplifier’s volume.
◆ If you want to control the TV’s volume
Slide the TV/DVD switch to TV.
Code numbers of controllable AV
amplifiers (receivers)
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your AV amplifier
(receiver).
* If you cannot control the volume of Sony STR-
DA3000ES/DA5000ES/DA9000ES AV
amplifiers (receivers) with the remote, enter the
code number 91 and check that the command
mode of the amplifier (receiver) is set to
“COMMAND MODE [AV1].”
See the instructions supplied with the amplifier
(receiver) to change the command mode.
For Sony amplifiers (receivers) other than
STR-DA3000ES/DA5000ES/DA9000ES, see the
instructions supplied with the amplifiers
(receivers).
z Hint
If you want to control the TV’s volume even when
the TV/DVD switch is set to DVD, repeat steps 1
and 2 and enter the code number 90 (default).
Portland 03
Proscan 10
Quasar 06, 18
Radio Shack 05, 14
RCA 04, 10
Sampo 12
Samsung 03, 12, 20
Sanyo 11, 14
Scott 12
Sears 07, 10, 11
Sharp 03, 05, 18
Sylvania 08, 12
Teknika 03, 08, 14
Toshiba 07
Wards 03, 04, 12
Yorx 12
Zenith 15
Manufacturer Code number
Number
buttons
[/1
VOL +/–
TV/DVD
switch
Manufacturer Code number
Sony* 80, 88, 89, 91
Denon 84, 85, 86
Kenwood 92, 93
Onkyo 81, 82, 83
Pioneer 99
Sansui 87
Technics 97, 98
Yamaha 94, 95, 96