Sony STR-DA777ES - Manual (Page 22)

22
Hooking Up and Setting Up the Speaker System
PHONES
SPEAKERS
A OFF A + B B
MEMORY – + – + A.F.D FM / AM TUNER PRESET
0 10
MULTI CHANNEL DECODING
OPEN/
CLOSE
MASTER VOLUME
1 9
8
7
2
3
6
5
4
AUDIO SPLIT DIGITAL / ANALOG
1 / u
+
ENTER
EQ SUR LEVEL
TUNER CUSTOM SET UP
VIDEO S-VIDEO L AUDIO R
MASTER VOLUME 1/u
–
2 CH ANALOG DIRECT EQ BANK 5.1CH INPUT SOUND FIELD PRESET SOUND FIELD
INPUT SELECTOR
– + MODE
INPUT SELECTOR
Before turning on the receiver
Make sure that you have:
• Turned MASTER VOLUME to the leftmost position (0).
• Selected the appropriate front speakers (see “@∞
SPEAKERS selector” on page 27).
Checking the connections
After connecting all of your components to the receiver,
do the following to verify that the connections were made
correctly.
1 Press 1/u to turn on the receiver.
2
Rotate INPUT SELECTOR to select a component
(program source) that you connected (e.g., CD
player or tape deck).
3
Turn on the component and start playing it.
4
Rotate MASTER VOLUME to turn up the volume.
If you do not obtain normal sound output after
performing this procedure, look for the reason in the
checklist on the following page and take the appropriate
measures to correct the problem.
Notes
• The rear balance, center level, and rear level are shown in the
display during adjustment.
• Although these adjustments can also be made via the front
panel using the parameters in the LEVEL menu (when the test
tone is output, the unit switches to the LEVEL menu
automatically), we recommend you follow the procedure
described above and adjust the speaker levels from your
listening position using the remote control.
z
When setting the volume levels for each speaker
Let’s assume that you have matched the sound levels of all the
speakers using the test tone. Although this lays the foundation
for high quality surround sound, it may be necessary to make
further adjustments while listening to playback of actual
software. This is because most software contains center and rear
channels recorded at slightly lower levels than the two front
channels.
When you actually playback software recorded in multi channel
surround you will notice that increasing the center and rear
speaker levels produces a better blend between the front and
center speakers and greater cohesion between the front and rear
speakers. Increasing the level of the center speaker about 1 dB,
and the rear speakers about 1~2 dB is likely to produce better
results.
In other words, in order to create a more cohesive soundstage
with balanced dialog, we recommend that you make some
adjustments while playing your software. Changes of only 1 dB
can make a huge difference in the character of the soundstage.
Before You Use Your
Receiver Multi Channel Surround Setup