Sony STR-DA777ES - Manual (Page 27)

27
Location of Parts and Basic Operations
!£ EQ BANK button
Press repeatedly to select an equalizer (EQ PRESET
1~5) or turn the equalizer off (EQ PRESET OFF).
z
To maintain the highest fidelity to the original source
Do the following to bypass the sound field and equalizer circuits.
1 Press EQ BANK to turn off the equalizer.
2 • When listening to multi-channel sources, press A.F.D. to turn
off the sound field processing.
• When listening to two channel (stereo) sources, press 2 CH to
bypass the sound field processing.
The result will be a sound that is highly faithful to the program
source.
!¢ MASTER VOLUME control
After turning on the component you selected, turn to
adjust the volume.
!∞ OPEN/CLOSE buttons
Press to open/close the door on the front panel.
Note
The door may suddenly stop if an external force is applied
while it is being opened or closed. When this occurs, do not
attempt to open or close the door by hand. Remove the cause
of the force, then press OPEN/CLOSE again.
If the door stopped while being closed, the door
automatically opens again a few seconds after closing. If the
door stopped while being opened, the door remains where it
stopped.
!§ ENTER button
Press to enter the index name (page 47) and clear
settings.
!¶ Cursor buttons ( / )
Press to select various speaker level, surround, and
equalizer parameters (etc.).
!• Jog dial
Turn to adjust the selected speaker level, surround,
and equalizer parameters (etc.).
!ª SET UP button
Press to activate the setup mode, then use the cursor
buttons (!¶) to select the parameters. You can then
make various settings using the jog dial (!•).
@º LEVEL button
Press to activate the speaker level parameters (page
35). You can adjust the various speaker level
parameters (front balance, rear balance, etc.).
@¡ CUSTOM button
Press to activate custom parameters (page 35).
@™ SUR button
Press to activate the surround parameters (page 35).
You can adjust the various surround parameters (effect
level, wall type, etc.).
@£ TUNER button
Press to activate the tuner menu.
@¢ EQ button
Press to activate the equalizer parameters (page 35).
You can adjust the various equalizer parameters.
@∞ SPEAKERS selector
Set according to the front speakers you want to drive.
Set to To select
A The speakers connected to the FRONT
SPEAKERS A terminals
B The speakers connected to the FRONT
SPEAKERS B terminals
A+B* The speakers connected to both the FRONT
SPEAKERS A and B terminals (parallel
connection)
OFF No speaker output
* Be sure to connect front speakers with a nominal impedance of 8
ohms or higher if you want to select both sets (A+B) of front
speakers
PHONES jack
Use to connect stereo headphones.
Connecting headphones cuts the output from the PRE
OUT jacks and speaker terminals.
When the headphones are connected, if 2 CH or
AUTO FORMAT DECODING is selected, 2 channel
stereo is output. If any other sound field is selected, it
is automatically changed to “HEADPHONE
THEATER”.