Sony STR-DA777ES - Manual (Page 46)

46
Settings and Adjustments
Other Settings <CUSTOMIZE>
p Phase polarity of the input source
ABS PHASE [NORMAL]
Initial setting : NORMAL
Lets you set the absolute phase polarity of the input
source. Normally, set to [NORMAL]. When outputting the
sound of a source of reverse phase, set to [REVERSE].
When set to [REVERSE], the polarity of the signals output
from all the speakers and PRE OUT jacks is reversed from
the current polarity.
Note
This setting does not change the polarity of the sub woofer to the
front speakers. To change the phase polarity of the sub woofer to
the front speakers, set S.W PHASE to REVERSE in the SP SETUP
menu.
p Digital filter frequency response type
DF ROLL OFF [STD]
Initial setting : STD
Lets you change the digital filter frequency response of
the D/A converter.
• STD: Standard frequency response.
• SLOW : The curve of the treble range is smoother than
with STD. You can enjoy a different sound from STD.
p Test tone noise type
NOISE BAND [STD]
Initial setting : STD
You can change the type of test tone noise.
• STD reproduces a standard test tone with the frequency
response recommended by Dolby Digital.
• WIDE reproduces a “white noise” test tone. You can use
to match the sound of the speakers.
p Sub room hookup
2ND AUDIO [SOURCE]
Initial setting : SOURCE
Lets you output audio signals to a stereo amplifier located
in another room. Select the source to output the audio
signals to the sub room. When [SOURCE] is selected, the
analog signals of the source selected as the function are
output to the sub room.* Be sure to hook up the stereo
amplifier in the sub room to this receiver using the 2ND
AUDIO OUT jacks (see page 11).
* However, if 5.1 CH is selected as the function, the analog
signals of the previously selected source are output to the sub
room.
The CUSTOMIZE menu allows you to customize various
aspects of the receiver’s operation.
p Audio split
V:VIDEO3 A:CD
Use to switch the audio source. (Same as the AUDIO
SPLIT button on the front panel.) See “3 AUDIO SPLIT
button” on page 25 for details.
p Audio input mode
DVD: AUDIO [AUTO]
Initial setting : AUTO
Use to switch the input for the current component. (Same
as the DIGITAL/ANALOG button on the front panel.) See
“4 DIGITAL/ANALOG button” on page 25 for details.
p Digital input decode mode
DVD: DECODE [AUTO]
Initial setting : AUTO
Lets you specify the type of signal being input to currently
the selected digital audio jack. The settings are stored
independently for each jack.
• AUTO : The unit automatically switches between DTS,
Dolby Digital (AC-3), and PCM.
• PCM : All input signals are treated as PCM signals. If a
Dolby Digital (AC-3), or DTS signal is input to a jack set
to PCM, no sound will be heard. If a jack is set to
“AUTO”, and a CD player or similar component
connected to that jack sounds interrupted when
playback begins, select “PCM” for that jack.
p Display dimmer control
DISP DIMMER XXX%
Initial setting : 100%
Lets you adjust the brightness of the display window.
It can be adjusted in 10% steps from 50 to 100%.