Sherwood R-865 - Manual (Page 21)

ENGLISH
21
• If the command has been learned successfully,
“OK” is displayed and then “SEL” is flickering.
• If “ERROR” is displayed and then “SEL” is
flickering, it means that for some reason the
command was not learned. In this case, repeat the
above steps
and .
Notes :
• If an incorrect signal has been sent or, in some
cases, the command from other remote control
simply cannot be learned.
• In some “ERROR” cases, the remote controls just
need to be moved closer together or farther apart.
Programing the commands from other
remote controls( LEARNING mode )
Press and hold down the ENTER button
and the desired one of the DEVICE buttons
for more than 2 seconds.
2
Place this remote control and other remote
control facing each other at a distance of 5
to 15 cm (2 to 6 inches ) apart.
1
While “SEL” is flickering, on this remote
control, press the button corresponding to
the function to be learned.
Example) If the function to be learned is playback,
press the PLAY( ) button.
4
While “SEL” is flickering, repeat the above
steps
and to program all the
commands you want to the buttons on this
remote control under the same device mode.
6
Repeat the above steps to to program
the commands from a different remote
control. 7
Operate the newly programmed buttons to
make sure the learning function was
performed properly.
8
• Then “SEL” is flickering.
• If “SEL” goes off, start again from the above step
.
• If the setup codes are not available for your component
or you want to program a missing or special function
into one button of a device, the learning function
enables this remote control to learn the commands
from other remote controls.
• Then “READY” is displayed.
Note:
• You cannot program a function into some buttons
such as DEVICE, MACRO and LIGHT buttons.
To exit from the setting mode, press any of the
DEVICE buttons.
• Then “LEARN” is displayed on the LCD screen for
several seconds
Note :
• During setting operation , to exit from the setting
mode, press any of the DIVICE buttons.
While “LEARN” is displayed, press the
ENTER button.
3
While “READY” is displayed, on the other
remote control, press the button of the
function to be learned.
5
ENTER
POWER TUNER VIDEO1 A B AUTO MUTE SLEEP
DIMMER
SPK SET ADJUST
12
3
4
5
67
8
9
0
CH.SEL
T.TONE
DSP
STEREO
VOL.
LEVEL
LEVEL
DECK SEL
INTRO P.SCAN
REPEA
T
VIDEO2
VIDEO3
7CH DIR
CD
AUX
T APE ST ANDBY
VOL. CD TA P E A B < <
PL II P ARA
5 to 15 cm
(2 to 6 inches)