Sherwood R-865 User Manual
Page 58
ENGLISH
58
• Each time these buttons are pressed , the
COMPONENT VIDEO INs change .
Note :
• In such a case that a COMPONENT VIDEO IN is
assigned to two input sources or more, when these
input sources are selected, the component video
signals can be viewed from the same COMPONENT
VIDEO IN.
• Each time these buttons are pressed, “
” and
“
” are moved to the corresponding
COMPONENT VIDEO IN.
Press the CURSOR UP(
)/DOWN(
)
buttons to select the desired input source.
2
Repeat the above steps
and
until the connected COMPONENT VIDEO INs are assigned to
the desired input sources respectively.
4
Press the CURSOR LEFT(
)/RIGHT(
)
buttons to select the desired
COMPONENT VIDEO IN.
3
• When performing recording with the video
recording component connected to VIDEO 2
(/ROOM 2) IN/OUT jacks, you should set the
VIDEO 2 OUT to On and deactivate the ROOM 2
function.
Note: When the ROOM 2 function is activated,
ROOM 2 source playback will be
performed regardless of the VIDEO 2 OUT
setting.
Press the CURSOR UP(
)/DOWN(
)
buttons to select the VIDEO 2 OUT.
1
When selecting the VIDEO 2 OUT
• Each time these buttons are pressed, the mode
changes as follows:
On : Select this to output the signals of the selected
source as a recording (main room) source from
the VIDEO 2/ROOM 2 OUTs.
Off : Select this not to output the signals.
Press the CURSOR LEFT(
)/RIGHT(
)
buttons to select the desired mode.
2
Continued