Sherwood R-865 - Manual (Page 25)

ENGLISH
25
Operating a punch-through function
• Each time the CURSOR UP( )/DOWN( ) buttons
are pressed, depending on the selected punch-
through mode, the punch-through devices and the
deleting mode (“DELETE”) are selected.
• Then “OK” is displayed and the current punch-
through mode is displayed .
While “VOL” is displayed, press the
CURSOR UP(
)/DOWN( ) buttons to
select the punch-through mode to be erased,
then press the ENTER button.
2
While the punch-through mode is
displayed, repeat the above steps
and
to erase other punch-through function under
the same master device mode.
4
Perform the steps and in “Entering a
setup code” procedure on page 19 to select
a master device and the punch-through
mode (“PUNCH”).
1
While the device is displayed, press the
CURSOR UP(
)/DOWN( ) buttons to
select the one punch-through deleting
mode(“DELETE”).
3
• While this remote control is set to control a master
device, aim the remote control at the REMOTE
SENSOR of the punch-through device and press the
desired button of the programmed punch-through
controls.
Example ) When pressing “PLAY ( )” button.
Erasing the programmed puch-through
function
• Then the punch-through device is displayed on the
LCD screen.
• Then “VOL” is displayed on the LCD screen for
several seconds.
• Each time the CURSOR UP( )/DOWN( ) buttons
are pressed, the mode changes as follows:
VOL DELETE PLAY CH
• Then the device is displayed .
To program punch-through functions under
other master device mode, repeat the above
steps
to .
5